Wiring cleanup

[Bill Cook]

Anybody have ideas to clean up the spider web of wires and cables?

[Hard Tail]

I'm no expert but I found by routing the main loom wiring directly up the frame and across the top bar to the head stem, and coiling the excess under the control panel the whole thing is fairly neat.

[Felix D'Kat]

I was going to get some of this stuff, comes in 3 different sizes, split plastic conduit, only about a dollar a meter.

http://www.ebay.com.au/itm/7-10-20mm-10-Metres-Management-Convoluted-Tubing-Wire-Split-Loom-Conduit-Cable/161743432552?hash=item25a8a8eb68:m:mtFkjNMsR5SgJJGUYGKIH6Q

[artdrectr]

I used something similar from amazon (usa) and it worked well.

http://amzn.to/2mY81bb

I coiled excess wiring around the seat tube near the BB. Wrapped that portion of coil and tube in 2" wide velcro. Hides the wiring and easy to remove.

http://amzn.to/2DwwEGc

[Bill Cook]

Thanks for the tip! Just ordered a variety of sizes from Amazon. See attached "before" photo. Will post results after get delivery.

[artdrectr]

Off thread: Seems like an odd location for the shift sensor. I thought it needed to be held in place like on a chain stay. If it works where ya have it, cool.