91 Cell Battery layout

[Jcnsdad]

I am at my wits end trying to find out the best way to lay this battery pack out. I have read so many instructions and looked at a lot of photos with no clear way of laying it out. I am trying to make a 52v 20 AH pack with 91 cells. the cells are recovered from backup packs with minimal use. the specs are:

Model:	LGABF1L1865 (INR18650F1L)
Capacity:	3350mAh Rated
Voltage:	3.63V Nominal
Charging:	4.20V Maximum 975mA Standard 1625mA Maximum

The bike motor is an Janopay 1,000WAH 48v-52v I have attached a layout that I put into my battery layout not sure its correct or how to connect what to what.the battery holder is a Polly DP-9 Down Tube max load of 91
If anyone could help me with the layout I would appreciate it I would like to just do the pulling of the nickel strips only once. If more info is needed just let me know.

Thank you

[Diggs Ut]

I'm assuming you got the help you needed by dual posting on Endless Sphere?

[AZguy]

I am at my wits end trying to find out the best way to lay this battery pack out. I have read so many instructions and looked at a lot of photos with no clear way of laying it out. I am trying to make a 52v 20 AH pack with 91 cells. ...

91cells in a 52V pack won't work out

52V pack is 14s so:

14s6p = 84cells
14s7p = 98cells

I suspect you will be looking to do a 14s6p

[Greeno]

91 cell battery is 7 x 13 which would be 48v.

Looking at your cell layout it's jacked up.

You have overlapping cell pos/neg locations.