Announcement

Collapse
No announcement yet.

Bbshd

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • leo32162
    replied
    Oh and also the display works speedometer works no watt.
    This morning oddly enough it wouldn’t wokrk at all after sitting all night

    Leave a comment:


  • max_volt
    replied
    Try disconnecting the batt for a minute and put back.
    This is troubleshooting a BBSHD/BBS02 that is not moving at all (no pedal assist or throttle).<br><br> If the motor moves on PAS but no throttle, just
    Last edited by max_volt; 01-11-2018, 07:14 AM.

    Leave a comment:


  • AZguy
    replied
    Battery contacts on shark batteries are a common issue and easily resolved by bending the contacts on the battery back in shape - definitely worth checking if you have a shark...

    Leave a comment:


  • leo32162
    replied
    I’m on my I didn’t know a BMS would go on and off like that

    Leave a comment:


  • leo32162
    replied
    No I never thought of it being the BMS I didn’t know a BMS would e thatgo on and off lik

    Leave a comment:


  • leo32162
    replied
    Completely shutting down no assist no throttle. The motor is pretty hot after around 10-20 minutes it will work again.

    Leave a comment:


  • max_volt
    replied
    When you talk shutting down, do you mean losing assist or going totally dead?
    Maybe batt sag from cold temps and age.

    Leave a comment:


  • artdrectr
    replied
    How have you ruled out the battery not being the problem? The BMS also acts as a shutoff.

    Leave a comment:


  • leo32162
    started a topic Bbshd

    Bbshd

    I have had my bbshd for about seven months and put almost 2k miles on it. It has been pretty reliable until about a month ago when it started shutting down on me on my commute back home. You see I have hotrodded from Luna and it ran at between 1000-1500 watts so it was over heating I assumed. What need to ask is does anyone have any ideas of what the problem is and how to fix it (ie. is it the controller, is it that I fried my windings to much) you see as long as I keep it under 1000 watts it will run, but now it’s getting more and more sensitive I'm getting a little frustrated to say the least. Any and all views are welcome
Working...
X