Hello guys, new guy here.
I have a Continental Prime 48v mid-drive ebike with a dead controller. I want to install a KT s06s in the motor housing completly replacing the old controller, display and pas sensor. My only concern is the hall sensors. There are only 4 wires which i identified one to be GND and the remaining 3 to be signal. I tried the pull-up 10k to 5v but i got no signal. Should i try lower 4.7k? I dont want to install a cheap square wave controller that do work with-out hall. What would you suggest?
I have a Continental Prime 48v mid-drive ebike with a dead controller. I want to install a KT s06s in the motor housing completly replacing the old controller, display and pas sensor. My only concern is the hall sensors. There are only 4 wires which i identified one to be GND and the remaining 3 to be signal. I tried the pull-up 10k to 5v but i got no signal. Should i try lower 4.7k? I dont want to install a cheap square wave controller that do work with-out hall. What would you suggest?
Comment