Bike has been great for 2000 miles. Updated the display and added Mobil grease. Perhaps a week later, the PAS quit working and I throttled everywhere. Then I figured out that I could start pedalling, activate the throttle for a few seconds, and PAS would start and run...until it stopped due to a break cutout or a shift. Then I need to kick-start it again by throttling.This behavior is intermittent.
I reset my configurations--all looked good. I replaced the controller. Still behaves identically.
I'm about to swap back to the old display unit.
Any suggestions?
I reset my configurations--all looked good. I replaced the controller. Still behaves identically.
I'm about to swap back to the old display unit.
Any suggestions?
Comment