Announcement

Collapse
No announcement yet.

Front Mac motor significantly off center

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

    Front Mac motor significantly off center

    I am trying to install a front Luna 5T Mac Motor in my Ryan Recumbent. The Luna laced rim is centered on the motor and therefore not dished to fit in the forks. It seems like the wheel builder built it like it was a rear wheel. Any suggestions?

    #2
    To some extent amount of dish will vary depending on the frame. On the side you want the tire moved toward, equally tighten each spoke. Then on the other side equally loosen each spoke.

    Comment

    Working...
    X