A while back ago I attempted to program My Bafang BBSD with my Luna program box . Noticed that when I tried to change the amp setting from 25 amps to 30 , it refused . So I took a chance and bought a new controller from Luna Cycle . That did it ! came preprogrammed set to 30 Amps . I have not had a chance to try it out yet . Weather here is below freezing !
Wanted to thank Luna Cycle !
I will update the thread once I get a chance to try it out , but so far so good.
Replacing it was not too bad , except for one small connector that was covered in silicone I had to pick away at
here is the vid I used https://www.youtube.com/watch?v=rgFQK-ID8AM
here is the controller
Again Hats off to Luna cycle !
Wanted to thank Luna Cycle !
I will update the thread once I get a chance to try it out , but so far so good.
Replacing it was not too bad , except for one small connector that was covered in silicone I had to pick away at
here is the vid I used https://www.youtube.com/watch?v=rgFQK-ID8AM
here is the controller
Again Hats off to Luna cycle !
Comment