Talaria Troubleshooting

[Sebz]

Talaria MX4-R troubleshooting section


If you have an error code on the display, please check this error code chart below:


FAQ:

• How to remove , replace and calibrate a controller?
• Rear wheel locking up
• Display stuck on WAIT
• Error 37
• Error E33 42 & 43
• Squeaky fork
• Torque setting chart
• Battery rattle
• Brake problem

If you're having issues assembling your bike, please take a look at the unboxing video down below

[Sebz]

Rear wheel locking up?

please watch this video

[Sebz]

How to remove , replace and calibrate a controller?

[Sebz]

Front fork is sticking or makes squeaky noises?

Please watch this next video and try to lubricate the dust wipers and seals.

https://www.youtube.com/shorts/GZwgl7pnSnY

[Sebz]

Torque setting chart:

[Sebz]

Brake problems

Brake rotor is rubbing?

Is the lever spongy? braking is weak?

If yes please click this link , it's a 3 step process and can fix most brake problems


If after all that you are still having issues best would be to bleed the system.

[Sebz]

Battery rattling? You likely didn't watch our unboxing/setup video and never installed the battery foam blocks.

Skip to the 14 minute mark and you will see how to install them

[Sebz]

Error 37:

This is the throttle connector not fully plugged in.



Please watch this video at the 13 minute mark

[Sebz]

Display stuck on WAIT and motor does not turn?

It's very likely a throttle or sensor that is the cause for this. so you will have to unplug them one by one to find which one is having issues.

• Reset the throttle back at rest position, if not at rest the bike will not start
• unplug brake sensor, you have 2 of them follow the brake lever wire, it's a round connector
• Unplug the kickstand sensor, you can trace the connector from the kickstand, it's located under the bash guard. if not sure how to remove please watch the controller replacement video:

How to remove the bash guard: