Spare tube damage?

[73Eldo]

Pinch flats was something I was worried about because I'm at or above the weight limit on a typical bike but it just hasn't been an issue for me. The...

[73Eldo]

Sealant would have helped the spare tubes but not the original issues which was I would guess a defect that split and then a 3/8 stick that went through...

[73Eldo]

Bontrager and Specialized brand tubes. As far as I know they are just standard grade normal tubes. On my 29er with the 2.5 tires I'm now running Bontrager...

[73Eldo]

Only had 2 flats and both times my spare tube has also been bad. Both tubes spent at least a year riding in my trunk bag. Both of them seemed to fail...

[73Eldo]

45Nrth makes a T handle tool for installing and removing the studs. Its not showing up on their site but many online stores seem to have them and cost...

[73Eldo]

With most ebike battery BMS's if they go into a low voltage protect mode they won't reset till you charge them but that isn't a firm rule so its possible...

[73Eldo]

When did you buy it? Mid/late 2020 seems to have been when most that have been reported here seem to have been made. What is yours doing?

[73Eldo]

Usually the issue with this type of battery is that it seems to charge too fast and then discharge fast so basically you loose range. Hopefully this...

[73Eldo]

I tried it today. Fairly short ride, about 12 miles. Got some new sounds. First sound is a clicking when coasting. Its worst in the lower gears so...

[73Eldo]

Mine is pre through axle so slightly less complex. I have never seen a through axle one up close and wondered how they did that. I would have to...

[73Eldo]

I just suggest zip tie for every problem. Eventually its got to work on something.

[73Eldo]

If you have horizontal drops and you can't run all the way forward you may need some sort of tensioner or spacer like these: https://surlybikes.co...

[73Eldo]

Here is an example of a DC-DC converter that will take 32-60vdc and turn it into 12v to run your stereo. I'm not saying this is a quality unit, just...

[73Eldo]

Last year I considered a GT Aggressor Pro from Dicks for a friend, quick look now they appear to be available but $600. At the time I remember them...

[73Eldo]

Did you look through all the hardware that came with your kit? Some of the kits I have installed came with some longer bolts and spacers but it depends...

[73Eldo]

Congrats if you manged to make it all the way thorough the Axum tread. It kinda turned into a longer term review and chat between Dishue and I. If...

[73Eldo]

Sounds alright to me. Also doesn't seem like you have any other good options. I keep mine in an unheated garage and ride in the snow. If I know...

[73Eldo]

With a reasonable amount of effort I can't find any decent specs for that bike. Every site it comes up on including apparently Motobecanes is a terrible...

[73Eldo]

How much power gets sent to the motor is up to the controller. If the controller is properly programmed (and able to handle a high voltage) you could...

[73Eldo]

Bafang who is one of the larger ebike component manufacturers often uses 1's and 9's so like 1919, 9191, 9119, 1991 that sort of thing. Even if its...