500c mini display, fully charged battery only showing 3/4 full on gage.

[Steve--]

Hah, I got distracted and forgot all about it until just now when coming across this post while closing some of my tabs. I'll try to check tomorrow :...

[Steve--]

P.S. Also, my comment wasn't specific to any particular speed, but rather about the laws of physics in general. I am a physicist by the way....

[Steve--]

I also do not intend any offense. However, mine was a general statement based on the laws of physics, and are not a matter of opinion....

[Steve--]

paxtana Why is your post unquotable? Is that by design, or some glitch?

[Steve--]

I'll try to check my markings today at some point. It is here in the house a few feet away from me, but t's not quite as simple as just going over there...

[Steve--]

You'll hear a lot of people say a lot of different things, and you can dink around with changing gear ratios, and tire diameters, and that certainly will...

[Steve--]

I've been in communication with a third party who is in communication with the manufacturer, and they're claiming that it could be due to my BBSHD having...

[Steve--]

Just to be clear, the stock chain ring that came with my BBSHD already has about a 3/4 inch offset to the inside. You're saying that the two examples...

[Steve--]

Is there a chain ring option for the BBSHD that has a deeper inside offset than the stock chain ring? Even though I don't have a fat bike, I bought the...

[Steve--]

lmao, that's a good one. Although... A sheet of plywood set horizontal actually is pretty damn aerodynamic :)...

[Steve--]

Update: I'm putting together a package for a friend of mine, and part of that package was another 500c display. Since I'm having this issue with my display,...

[Steve--]

That could be true, but I don't see a setting with that exact nomenclature. All I see is the "Low Batter Protection [V]" setting, which I have...

[Steve--]

I thought the same thing and tried this, but regardless of which battery voltage I set it at, it still reads 75% at a full 54.6/7 volt charge. So there...

[Steve--]

Yeah, I'm happy with the display other than this issue. It's not just a small oversight though. That's one of the main features of the display, and there's...

[Steve--]

Mine is a 48 volt battery, and i have the display set to 48 volts. And as far as I know, the displays still aren't intended to give an accurate read on...

[Steve--]

I have it set to voltage instead of percentage, and it reads 54.6 to 54.7 volts. My multimeter also confirms this voltage. Again, however, the actual...

[Steve--]

Well that's pretty simple, it's because when we buy these cables we're not buying them directly from the manufacturer, we're buying them from some middle...

[Steve--]

Yet another 3 years later, as Espresso said, I know this is an old thread, but today in 2021 the "Error opening serial port!" is still an issue....

[Steve--]

Just got a new programming cable in 2021, using windows 10 and still had this same issue. But the ch340 chip driver retrocycler linked to fixed my issue....

[Steve--]

I would think as long as you keep your laces short and tight that they'll be fine. Even if they did get caught I don't think it would be much of an issue...